Stages Bike - StagesBike SB20 User Guide

Shifters & Controls

The StagesBike is equipped with functional brake levers for slowing the flywheel and electronic buttons on the insides of the brake hoods for shifting gears. Accessory buttons (located on the brake hoods behind the shift buttons) can be used for additional features supported by third party apps. A second set of shift buttons is located on the insides of the handlebar drops. This secondary set of buttons can be repositioned anywhere along the handlebars.

When the bike is powered on, the brakes will slow down and stop the flywheel. Each lever can apply up to 50% of total resistance, resulting in 100% resistance when both levers are fully actuated. The button/shifter configuration on your StagesBike can be set to Shimano, Campagnolo, or custom defined from within the Setups page of the Stages Cycling app.

To choose your preferred button configuration:

  1. Select the Devices menu and select the StagesBike SB20.
  2. Select the Setups tab, then open or create a new setup.
  3. Select Button configuration.

The default button configuration is shown in the table below:

 

                            Left (L)                                                    Right (R)

Left brake hood with buttons labeled 3, 2, 1 (left to right) and lower buttons labeled 1,2 Right brake hood with buttons labeled 1, 2, 3 (left to right) and lower buttons labeled 1, 2.

Button ID (Left) Function Button ID (Right) Function
L1 Front gear harder R1 Rear gear harder
L2 Front gear easier R2 Rear gear easier
L3 External app control R3 External app control

SEARCH RESULTS FOR:

"term"