Stages Bike - StagesBike SB20 User Guide

Power Meter Setup

The StagesBike is outfitted with Stages L/R Power meters. Before riding, remove the battery insulation tabs from each power meter.

  • Required: small Phillips head screwdriver.

To remove the tabs:

1

Loosen the battery cover screws.

Screwdriver and counterclockwise arrow aligned with the two battery cover screws. A blue arrow is shown in front of the battery tab pointing away from the power meter.

2

Pull on the insulation tab until it is completely removed from
the power meter housing.

Blue arrow points away from the power meter and battery tab, shown fully removed from the battery housing.

3

Tighten the screws to secure the battery and cover.
Caution: Do not over-tighten the screws as this may damage the battery case.

Screwdriver and clockwise arrow aligned with the two battery cover screws.

SEARCH RESULTS FOR:

"term"