Installing the Mount

Once you’re ready to ride, you will need to install your Stages Dash mount onto your bicycle to get going. Each Dash comes with an out-front style road mount, with several other after market mounts available for purchase. A 2.5mm hex wrench will be required to install the Dash mount on your handlebars.

Instructions:

1. Position handlebar clamp ring (5) to the right of the stem and between any cables and the 31.8mm handlebar
2. Insert the two M2.5 screws (4) into the holes of the clamp ring (5) and use a 2.5mm hex key (3) to loosely tighten ring on handlebars
3. Adjust mount to preferred angle
4. Tighten screws (4) to 0.5 Nm.
   ⚠WARNING: DO NOT OVERTIGHTEN SCREWS.