Installing/Removing Dash

1. Install mount to proper specification (see Installing the Mount).
2. Orient device in either portrait or landscape position and line up with mount.
3. Make sure lip of the mount is behind the aluminum mounting rail.
4. Slide Dash downward until the thumb tab audibly clicks tab into place.
   
5. Check to make sure the thumb tab is properly seated in the mounting slot.
6. To remove, pull back on thumb tab and pull up on Dash. The Dash should come out easily, if you are forcing it, pull further back towards the bike with the thumb tab.

To install the included safety lanyard (recommended):

1. With the Dash removed from the mount, insert the loop end of the lanyard into the hole on the unused mounting location on the Dash.
2. Pull the lanyard cord end through the loop.
   
3. Slip the elastic side of the lanyard over the thumb tab and mount arm.
4. Make sure the lanyard is completely clear of the thumb tab.
5. Install the Dash onto mount.